his web site is using cookies.
If you continue to use the site you accept that we use cookies. Click to read more about our use of cookies
New products
Webshop
Giftcards
Special offers
Fixed wing models
Helicopters
Multirotors
Radio Equipment
Drive System
Batteries
Charging
Accessories
Flight simulator
Smoke and visual effects
Landing gears
Wheels
Wheelspats
Glue
Tape
Connectors
Raw wire
Switches
Shrinking tube
Building materials
Rods
Tubes
Profile
Balsa
Plywood
Depron
EPP
Linkages and hinges
Screws and Nuts
Covering
Other Accessories
Bags & cases
Tools
Spare parts
Carbon Rod 5.0 mm x 1000 mm
€ 4,97
Prices given are in EUR excluding VAT
€ 4,97
In stock  On stock and ready to ship
DPP Carbon fibre round solid rods pultruded
Pultruded carbon-fibre rods by Van Dijk Pultrusion Products from HT carbon fibres (T300 or equivalent) and epoxy resin are drawn continuously through a die. This production method causes the fibres to be oriented unidirectionally, i.e. along the length of the pultruded form. The result is a high fibre volume fraction of 62 % with a very low air voids content and a heat distortion temperature of 120 °C.

Tolerances:



DPP Carbon rods:

ca. 1–3 % Diameter
DPP Carbon tubes:
Up to 1 mm outer-Ø: outer-Ø ± 0,03 mm, inner-Ø ± 0,03 mm
1,5 mm - 2,5 mm outer-Ø: outer-Ø ± 0,05 mm, inner-Ø ± 0,03 mm
Over 3 mm outer-Ø: outer-Ø ± 0,10 mm, inner-Ø ± 0,03 mm
A pre-treatment of the adherent is not nescessary. We do recommend to use epoxy resin or cyanacrylate (superglue) for the bonding itself.